2-21-2010 - Charge pipe heat wrap

Tidied a few things up on the car tonight.

Installed the grommet from the SO2 onto the wire leading into the cabin for the EGT gauge. At 6am when we finished the install of the DP, I just didn't have the consciousness to even think about it. Now that is sealed off properly and should keep water out.

A few of the couplers on the charge pipes weren't sitting the way I liked. So I loosened, adjusted and re-tightened them to make sure they would seal well. While I was in there, I decided to wrap the charge pipe leading to the throttle body with the same heat resistant wrap we used on the teg. As I have time, I'll probably go through and wrap several more of the pipes.